Motor
Manage motor drivers.
To add new motor use the + icon buttons on the right side and make a pre-selection of the family type of motor.
Enter the IP address and optionally change the name of the motor driver.
You may also enter the values of speed, acceleration/deceleration, microsteps per step and mm for motor revolution.
If the encoder is used, check the relevant box and enter the resolution value.
The selected motor controller is highlighted by -, to go to the next one select its name. To remove the selected motor controller, use the trash icon buttons on the right side.
In the event of communication problems with the device, a red triangle with an exclamation mark will appear next to the name of the affected device.
